High resolution of 0.5 μm0.020 mil

Thanks to high-precision measurement at a resolution of 0.5 μm 0.020 mil and an LED digital display that provides exceptional ease of use, the HL-G1 series will see use in a variety of applications on production lines worldwide.

Quick

Setup is fast and efficient by using the built-in digital display to set measurement parameters such as sampling cycle and output options.

Compact

The HL-G1 series features a compact design despite its built-in controller and digital readout. Thanks to our miniaturization technology, it can easily be installed on robot arms and in confined spaces.

Friendly

The HL-G1 series now features a userfriendly interface that offers improved ease of use when operating via computer software or HMI unit for more sophisticated operation and analysis.

Its lightweight resin body weighs 70 g approx., which can be installed on moving parts such as sliders and robot arms. Cable with superior flexibility is fitted as standard.

In addition to timing input select the desired input according to your application:

With three outputs, the HL-G1 can be used to generate HI / GO / LOW judgment output or alarm output. The analog output can be used in both current and voltage modes.

A single model number accommodates both NPN and PNP wiring polarity, reducing the number of model numbers that must be registered for maintenance purposes.

With three outputs, the HL-G1 can be used to generate HI / GO / LOW judgment output or alarm output. The analog output can be used in both current and voltage modes.

Up to four groups of sensor settings can be stored for fast recall. Easy switching among setting groups allows smooth setup changes.

The integrated communications interface lets the sensor communicate with upstream devices such as PLCs.

Sensors and other devices can be connected in a 1:1 manner using RS-422, or up to 16 HL-G1 series sensors can be connected using RS-485, enabling them to return measured values in response to messages from the PLC.
When using one of our PLCs*, you can use the PLC’s data write / read instructions (F145 and F146) to easily configure HL-G1 series settings and acquire measurement output.
* Supported PLCs from Panasonic Industrial Devices SUNX: FP0R, FPΣ, FP-X

Software tool for sensor configuration and evaluation (Free download available)

In addition to configuring up to 16 sensors at once, this free tool makes it easy to gather data needed for analysis, such as received light waveform monitoring and data buffering. The interface language can be selected at the time of installation.

● Data buffering Stores and displays measurement data, which can be superimposed on previously recorded data for easy comparison and analysis. ● Received light waveform display Displays the amount of light received by cell from lightreceiving element. ● Measured value display Displays measured values as well as the output state for each terminal.

HMI screen (Free download available)

The GT02 / GT12 series HMI can be used in combination with the HL-G1 to allow easy confirmation of sensor status and configuration of sensor settings from a remote location. Japanese, English, Chinese, and Korean are supported. For more information about the GT series, refer to the GT series pages.

・Measured value display
Displays measured values as well as the output state for all terminals.

* This software accommdates below language. You can select the language when installing.
・Japanese ・English ・Korean ・Chinese

Software tool and HMI screen data support not only Japanese and English, but also Chinese and Korean, providing a new level of support for devices and equipment in use worldwide.